《中国康复理论与实践》

《中国康复理论与实践》 ›› 2011, Vol. 17 ›› Issue (4): 386-389.

• 论文 • 上一篇    下一篇

小腿残肢负重压力取型系统的设计及应用

魏晨婧1，曹学军1,2，宋佳佳2，王林2   

  1. 1.首都医科大学康复医学院，北京市 100068；2.中国康复研究中心康复工程研究所，北京市 100068。
  • 收稿日期:2011-03-16 修回日期:1900-01-01 出版日期:2011-04-25 发布日期:2011-04-25
  • 通讯作者: 曹学军

Design and Application of Weight-bearing Pressure Casting System for Transtibial Stump

WEI Chen-jing, CAO Xue-jun, SONG Jia-jia, et al.   

  1. Institute of Rehabilitation Engineering, Capital Medical University School of Rehabilitation Medicine, Beijing Charity Hospital, China Rehabilitation Research Center, Beijing 100068, China
  • Received:2011-03-16 Revised:1900-01-01 Published:2011-04-25 Online:2011-04-25

PDF (PC)

被引次数

4

摘要： 目的设计小腿残肢负重压力取型系统实现全面承重的小腿假肢在取型中合理分配残肢末端的承重量。方法设计制作小腿假肢接受腔负重压力取型系统。6例患者均穿戴该方法制作的接受腔和传统手法取型制作的髌韧带承重接受腔，对比接受腔界面压力，评价取型效果。结果与髌韧带承重接受腔相比，使用本系统制作的接受腔承重更加均匀，在取型时就能完成对残肢的压缩和对残端压力的控制。结论负重压力取型技术可以制作全面负重的小腿假肢，提高接受腔适配性。

关键词: 小腿假肢, 接受腔, 全面承重, 压力取型

Abstract: ObjectiveTo design a weight-bearing pressure casting system for transtibial prostheses to make the total surface bearing socket and to control the stump and bearing during the casting process.MethodsThe weight-bearing pressure casting system was designed. 6 cases weared the socket by this method and traditional patellar tendon bearing socket by hand casting. Socket interface pressure was compared, and the effect of casting was assessed.ResultsCompared with patellar tendon bearing socket, the socket pressure in the socked by this method was distributed more equally throughout the transtibial residual limb during the casting process, and completed the stumps compression and stump-end pressure control.ConclusionWeight-bearing pressure casting system can make the total surface bearing socket, and improve the fit of the socket.

Key words: transtibial prostheses, socket, total surface bearing, pressure casting